How to Run the Draimad

How to Run the Draimad



There are two videos that show the operational aspects of the Draimad


DRAIMAD: RUNNING THE DRAIMAD


DRAIMAD: O&M TRAINING 


    • Related Articles

    • How to adjust shutdown run time or conveyor run time on CBB HMI

      This is password protected and the password changes randomly everyday and must be generated by us. Contact DRYCAKE support for further assistance. How to Enter PASSWORD: 1. With decanter stopped, go to page of the Password and Connection HMI reported ...
    • How much Air/Water is required for the Draimad?

      Quantity of air required: There is no a specific quantity of air consumption. All depends from the quality of flocculation and from the capacity of dewatering of the bag. Anyway please consider the compressor consumption: 15m3/h @ 45PSI(3bar) Water ...
    • How to check rotation of the Scraper on centrifuge

      The rotation of the blades of the scraper system should turn counter-clockwise (same direction as the main motor fan) If this is not the case check 1.General Power Polarity  Maybe the incoming power polarity needs to be changed. This can be verified ...
    • How to resolve Oil Cooling Alarm

      If you cannot reset the alarm after letting the machine rest and reset, then you can perform these troubleshooting steps. Check physical condition If you have an oil cooling alarm you must verify and ensure that there is no physical reason; such as ...
    • How to determine motor speed on Centrifuge

      Look at the VFD display for main motor. Read the running Hz From motor nameplate find the RPM corresponding to 60Hz installation  Scale RPM over 60Hz and find your current RPM based on the  Running Hz example: 3600rpm 60Hz = 60rpm/Hz = 1HZ=60rpm ...