How much Air/Water is required for the Draimad?

How much Air/Water is required for the Draimad?

Quantity of air required:

There is no a specific quantity of air consumption. All depends from the quality of flocculation and from the capacity of dewatering of the bag. Anyway please consider the compressor consumption: 15m3/h @ 45PSI(3bar)

Water Quantity:

 Water for washing is not necessary. Water with characteristics of potable water is necessary, only to fill the tank of the polymer preparation. ¾” size and 20-30PSI  pressure are OK.
    • Related Articles

    • How to Run the Draimad

      There are two videos that show the operational aspects of the Draimad DRAIMAD: RUNNING THE DRAIMAD DRAIMAD: O&M TRAINING 
    • How to resolve Oil Cooling Alarm

      If you cannot reset the alarm after letting the machine rest and reset, then you can perform these troubleshooting steps. Check physical condition If you have an oil cooling alarm you must verify and ensure that there is no physical reason; such as ...
    • How does 3 phase Decanter Centrifuge work?

      Three Phase Decanter Centrifuge Decanter 3 Phase is typically used to separate oil, water and solids. In these designs the cake is separated and removed as in the two-phase design.   Inlet sludge, through feed pipe, will be conducted inside bowl of ...
    • How to remove the rotating assembly from the centrifuge

      Important Before commencing the work to replace the bearing, make sure that the machine is off and put in the safety position(control panel is not powered). To lift out the rotating assembly, in order to for example replace the bearings, loosen the ...