How to Adjust pneumatic cone Screw press

How to Adjust pneumatic cone Screw press

Adjust actuator as below


    • Related Articles

    • How does a Screw Press Work

      We have prepared this video to understand the operating principle of the Screw Press
    • How to adjust shutdown run time or conveyor run time on CBB HMI

      This is password protected and the password changes randomly everyday and must be generated by us. Contact DRYCAKE support for further assistance. How to Enter PASSWORD: 1. With decanter stopped, go to page of the Password and Connection HMI reported ...
    • How to find weight of Bowl & Scroll Rotating Assembly for transport and lifting

      The weights per model are: DR800 -          Complete rotor (bowl, screw)= 4315kg -          Complete rotor, front support and rear support = 4895kg (4315kg, 290kg, 290kg) -          Complete rotor, front support and rear support, gearbox = 5555kg ...
    • How to go from 3 to 2 phase with the Decanter Centrifuge with the kit?

      If your Decanter Centrifuge was ordered with a special kit, it can be changed from 2 to 3 phases and vice versa From 3 to 2 phases 1.         Replace the oil levels with the plugs; ensure that there are O-rings on the plugs 2.Remove weir plates ...
    • How does 3 phase Decanter Centrifuge work?

      Three Phase Decanter Centrifuge Decanter 3 Phase is typically used to separate oil, water and solids. In these designs the cake is separated and removed as in the two-phase design.   Inlet sludge, through feed pipe, will be conducted inside bowl of ...